Edit User Data; Add Apparatus Models - Honeywell TESTAIR 4 Guide D'installation

6. Click Done when finished adding users.
6.3.3

Edit User Data

To edit an existing user's information, enter the User
List as described above and click on the up arrow.
Once the user's information has been changed, click
on the Check button to save the information.

6.4 Add Apparatus Models

Note: The Model Configuration Wizard is only available
in Standard Version TestAir 4 software.
All SCBA are made up of similar components including
a facepiece, a first stage regulator, a second stage
regulator, alarms, gauges and an air cylinder. Although
every SCBA is unique, there are general similarities
from model to model that HRSP uses to set the
appropriate baseline values for testing these
components.
The Model Configuration Wizard allows the user to
select components to create specific models from the
available of SCBA, Airline Apparatus, and Facepieces
that are used in testing.
Once the type of apparatus is selected, the Model
Configuration Wizard will automatically run through the
appropriate setup procedure. The user will need to
configure the model so that it matches the physical
specifications of the apparatus.
The testing procedure is automatically defined for the
apparatus model that is selected at the time of testing.
That apparatus is configured in the software by this
procedure.
The user entering apparatus information must have
level 4 software access or the Add New Model and/or
Add New Serial Number options may be unavailable.
See section 6.3.1 for a description of user software
permissions.
1. To enter a new apparatus, first select Setup /
Apparatus / Add New Model.
2. The Choose Model Screen will be shown and will
show a list of all models that are available for
testing. If this is the initial software launch, the
fields will be blank.
3. Click on New to enter the Model Configurator.
EN-7