Launch The Software; Pre-Test Requirements; Initial Login - Honeywell TESTAIR 4 Guide D'installation

6. Launch the Software

To launch the software, either double click on the
TestAir 4 icon located on your PC's desktop screen or
click on the start button to access All Programs /
Sperian / Posi3 USB / Fenzy / BATest / BATest.exe

6.1 Pre-Test Requirements

Before the software will allow the testing of breathing
apparatus, the following requirements must be met:
1. Log in to the software (see section 6.2).
2. Set up a new user account with the ability to
create and test apparatus in the software. The
Setup User doesn't have these rights, so at least
one new user must be created (See section 6.3).
3. Create an apparatus model in the software (See
section 6.4). Users with OEM software versions
will not have this option because the apparatus
models are included in the OEM software's built-in
database and cannot be modified.
4. Assign a serial number to the apparatus you want
to test (See section 6.5)

6.2 Initial Login

At the initial software launch, there will be no system
users in the database, so an initial User ID and
Password are used to enter the software.
The initial User ID and password are
both "Setup"
.
Note: User ID and Password are case sensitive.
After successful login, the software will prompt the
user to open the test results database that was created
during the installation procedure (see section 4.1
step 19 above).
Select the database and click Open.
The software will offer the option to search for software
updates and/or manufacturers bulletins.
If you wish to check for either of these items, click on
the appropriate options and then click Check.
Click "Done" to proceed to the initialization.
At the initialization screen, click the "Initialize TestAir 4"
checkbox to establish communication with the
instrument. The software must be able to communicate
with the TestAir 4 in order to perform tests.
EN-5