3
Operation
3.8 Vertical steam
You can also use the steam in upright position
(see 3.7). You can iron your curtains and hanged
garments thanks to the vertical steam feature.
Keep the appliance 15-30 cm away from the
garment and curtains.
WARNING: Never direct the
steam to people or pets.
4
Cleaning and care
4.1 Cleaning
WARNING: Do not soak the
steam station (2) in water or other
A
liquids. Never put vinegar, descaling
agent, laundry starch, perfume or
other auxiliary products that help
ironing into the appliance.
WARNING: Do not use gasoline,
A
solvent and abrasive cleaning
agents or hard brush to clean the
appliance.
WARNING: Do not wash your
B
appliance under running water or do
not soak it in water or other liquids.
A
WARNING: Do not use abrasive
cleaning agents to clean the
soleplate (8).
1. Switch off and unplug the appliance before
cleaning.
2. Wait for the appliance to cool completely.
3. Use a slightly damp cloth to clean the exterior of
the appliance. Then wait for it to dry completely.
4. Wipe the sediments and residues on the
soleplate (8) with a slightly damp cloth or with
a soft, nonabrasive liquid cleaner if necessary.
10 / 104 EN
3.9 Automatic Shutdown
(Auto-Off)
If you do not move the appliance or press any of
its buttons for 10 minutes, it will be shut down
automatically.
• If you move the appliance horizontally or press
any of its buttons, it will start to operate.
C
It may take 60 seconds for the
soleplate (8) to reach the previous
temperature level.
4.2 Replacing the lime
collecting cartridge
A
WARNING: Do not use any
descaling agents! They may damage
the appliance.
WARNING: Do not purchase
cartridge from places other than
the dealers and service centers. If
A
you do this, the cartridge will not fit
into the cartridge slot and will not
operate. This causes a breakdown
in your appliance. Faults arising
from using wrong cartridge are not
covered under warranty.
1. "
" symbol will flash on the control panel (10)
when the cartridge needs to be replaced.
C
The cartridge must be replaced after
consuming about 30 liters of water.
2. Soak the new cartridge in water for 5 minutes in
order to enhance its performance.
3. Before removing the old cartridge from its slot,
make sure that the sections surrounding the
cartridge is cold.
Steam Station / User Manual