Delta JT160 Manuel D'utilisation page 10

3. Insert a M6x1x16mm button head screw (G) Fig. 9 through fence tilting bracket (H) and thread a M6x1 square
nut (J) onto threaded end of screw (G). DO NOT COM PLETE LY TIGHTEN SCREW (G) AT THIS TIME. Assemble
screw and square nut to opposite end of tilting bracket in the same manner.
4. Slide groove of fence (L) Fig. 10 over square nuts (J).
G
5. Position fence (L) Fig. 11 so that rounded section (M) on bottom of fence is over cutterhead opening.
6. Tighten two screws (G) Fig. 12 using included hex wrench.
L
CUTTERHEAD GUARD
1. Locate the two M6x1x12mm button head screws (A) Fig. 13 in front side of jointer base. MAKE SURE THEY ARE NOT
COMPLETELY TIGHTENED AT THIS TIME.
2. Slide guard mounting bracket (B) Fig. 14 onto the two screws (A). Make sure cutterhead guard is touching the fence
and tighten the two screws (A).
H
J
Fig. 9
M
Fig. 11
A
Fig. 13
G
10
L
J
Fig. 10
G
Fig. 12
A
B
Fig. 14
A