Storch EasyMasker Mode D'emploi page 10

GB
Thank you
for purchasing a STORCH product. You have purchased a quality product.
If you would like to suggest an improvement, or experience a problem with your product, please do not hesitate to con-
tact us.
Please contact your field sales representative or, in urgent cases, contact us directly.
Yours sincerely,
STORCH Service Department
Tel.:
Fax:
Free service hotline:
Toll-free order hotline:
Toll-free order fax:
Table of contents
Loading with masking material (paper or foil) and adhesive tape
Fitting and replacing the blade
Application
Sinnvolle Ergänzungen aus dem STORCH-Programm
Loading with masking material (paper or foil)
and adhesive tape:
Lift the pressure roller, push the masking ma-terial onto
the paper/foil holder, and roll off in the direction of the
arrow. Press the adhesive tape onto the tape holder, pull
in the direction of the arrow and stick onto the edge of the
masking material. Pull the masking material and adhesive
tape together to the tear off edge and tear off the first
piece. The Easy-Masker is now ready for use.
Handle
Tape holder
Adhesive tape
+49 (0)2 02 . 49 20 - 112
+49 (0)2 02 . 49 20 - 244
0800 786 72 47
+49 800 7867244
+49 800 7867243
(only available in Germany)
Pressure roller Paper holder
Fitting and replacing the blade
Push the angled side of the tear off blade onto the holder,
and adjust to match the width of the adhesive tape (the
metal pin must be in-serted into the correct hole); then
push the metal pin into the hole until it clicks into pla-
ce. To remove the blade, push the blade upward with your
thumb until the blade dislodges.
10
Masking paper / -foil
Tear off blade
Page
10
11
11
11