Cleaning And Maintenance; Cleaning Your Greenstar Pro; Helpful Hints For Easy Cleaning - Tribest GreenStar Pro GS-P502 Mode D'emploi

CLEANING AND MAINTENANCE

Keeping your Greenstar Pro clean is extremely important for both your health and the peak per-
formance of the machine. We recommend cleaning the juicer immediately after each use, before
food particles have a chance to dry. Since Greenstar Pro extracts minerals, such as calcium, from
the produce so well, we recommend cleaning all of the juicing parts immediately after use to prevent
troublesome mineral build-up.
Cleaning Greenstar Pro
1. Switch off your Greenstar Pro and unplug it from the electrical outlet. Detach the power cord
from the rear of the machine.
2. Disassemble the machine according to the instructions on page 11 and immerse the juicing
components in warm water.
3. Using the included cleaning brushes, rinse and scrub the juicing components under warm running
water and a mild detergent.
4. Use the cleaning brush to remove any remaining bits of pulp that remain on the Twin Gears or on
the housings.
5. If using the Fine Screen, brush away from the corners and remove any pulp buildup.
6. Rinse all soapy water from the components; dry them thoroughly before they are reassembled.
All parts, expect the Safety Hood are dishwasher safe.
• NEVER allow water to enter the Main Body of the machine.
• NEVER use harsh chemicals, such as bleach, to remove food stains from the juicer.
• NEVER drop any of the components, particularly the Twin Gears. Our warranty does not cover
accidental damage.

HELPFUL HINTS FOR EASY CLEANING:

Cleaning the Screen: Attach the scraper attachment to the handle and use the tool to scrape off the
pulp residue on the juicing screen. Remove the scraper attachment and replace it with the cleaning
brush attachment to brush away the remaining pulp residue. For pulp that is embedded firmly in the
holes of the screen, try brushing away as much pulp as possible, soaking the screen for a couple of
hours in water, and then brush the screen again.
Cleaning the Main Body: Turn off and unplug the machine. To clean the Main Body of your juicer,
position the front two legs over the edge of the sink. With either the sink top sprayer, a spray bottle
filled with water, or an empty detergent bottle filled with water and equipped with its squirt-top,
spray water directly onto the front plate of the juicer where the drive shaft, mounting peg and free
wheel gear seats to remove pulp residue. Wipe any other exterior surfaces with a damp cloth. DO
NOT SUBMERGE THE MAIN BODY INTO WATER AT ANY TIME.
Multiple Juicing Sessions: If you want to juice throughout the day in multiple sessions without
disassembling the machine, completely remove the Juicing Knob, place a large bowl under both
the Juice Outlet and the Pulp Discharge Outlet, and pour about 16 oz. of water through the feeding
chute while the machine is running, before and after each juicing session. Make sure to thoroughly
clean the juicer after the last juicing session of the day.
18