Quick Start - NEC MultiSync LCD2070NX Manuel Utilisateur

Quick Start

To attach the MultiSync LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2. For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your
system (Figure A.1). Tighten all screws.
For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your
system (Figure A.2). Tighten all screws.
For the MAC: Connect the Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to
the Macintosh cable adapter (Figure B.1). Tighten all screws.
DVI signal cable
Figure A.1
NOTE: Some Macintosh systems do not require a Macintosh cable adapter.
3. Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position (Figure C.1).
4. Connect all cables to the appropriate connectors (Figure C.1).
NOTE: If connecting both DVI and D-sub cable, the DVI cable must be connected along side the rib on the power cord side
(Figure C.1).
5. For successful cable management, place the cables in this order into the cable management: Power cord and DVI cable
(Figure C.2).
6. Place DVI cable and power cord into the specific hooks indicated in Figure C.2.
7. Place the D-Sub and the USB cable into the specific hooks indicated in Figure C.2 (USB Cable: NX model only).
Highest
Stand
Position
DC-OUT
Power Cord
(Picture: LCD2070NX model)
01_English
30˚ Tilt
DVI Cable
Input1 (DVI)
Figure C.1
3
Macintosh
Figure A.2 Cable Adapter
(not included)
DVI Cable
Power Cord
Input2 (D-Sub)
USB
(NX model only)
(Picture: LCD2070NX model)
English-3
20/12/06, 10:18 AM
Figure B.1
D-SUB Cable
USB Cable
(NX model only)
Figure C.2