Ayce 2F12 Mode D'emploi page 37

Pick out the motor assembly (10), remove the pole nut (14) out off the supporting pole.
●
Align and insert the supporting pole into the hole of the base (13), fasten it with the pole
nut (14).
Remove the blade cap (3) and guard knob (5) from the motor shaft. Assemble the rear
●
guard (6) onto the motor assembly (10) and fixing it by the guard knob(5).
Assemble the blade (4) on the motor shaft (7) and secure it with blade cap(3).
●
Put the front guard (2) onto the rear guard (6), fixing it with the guard clip then fasten the
●
safety screw (1). Then you can use your desk fan by following below the operation.
OPERATION
Connect to the power source (220-240V AC, 50Hz) with the power cord and plug (11).
●
Rotate the switch knob (9) to desired air flow. "1" indicates low speed, "2" indicates
●
medium speed, "3" indicates high speed and "0" indicates off position.
Push the oscillating knob (8) for oscillation and pull the oscillating knob for fixed position.
●
The airflow can be adjusted upward or downward by simply moving the motor housing up
●
or down.
MAINTAINANCE
Always turn off and disconnect the power cord from the socket before carrying out any
●
cleaning operation.
Warning ! After assembly, never remove the guards for cleaning or maintenance purpose.
●
Use a moistened cloth (NOT WET) to clear the dirt from the plastic and metal surfaces.
●
Never immerse the fan in water or any other liquid.
●
If the fan is not used for a long periods, protect with suitable cover after cleaning , then
●
store in a dry place.
36 | 37
GB