Faber FBH 32 BK FFI Manuel D'utilisation page 13

To ensure that the hob functions prop-
erly, the pan must cover one or more of
the reference points indicated on the sur-
face of the hob, and must be of a suitable
minimum diameter.
Always use the hob that best corres-
ponds to the diameter of the bottom of
the pan.
Cooking areas
Ø min.(recommen-
Right rear
Right front
Left rear
Left front
Empty or thin-based pots/pans
12. TROUBLESHOOTING
Description
Error code
Hob switches off after 10
ER03
sec.
Hob switches off.
ER21
Corresponding
E2
area switches off.
Corresponding
E3
area switches off.
Hob does not switch on. Power supply voltage and/or frequency
E6
Cooking areas are turned
E8
off.
Corresponding
EH
area switches off.
Pan base diameter
Ø max (recommen-
ded) ded)
110 mm 200 mm
110 mm 145 mm
110 mm 190 mm
110 mm 190 mm
Possible causes of the error
Continuous key activation detected.
Water or pan placed on the control
panel.
The internal temperature of electronic
parts is too high.
cooking Empty or unsuitable pan.
Pan or ceramic glass surface temper-
ature too high.
Electronic component temperature too
high.
cooking Unsuitable pan.
The pan is losing its magnetic proper-
ties and may damage the induction
hob.
is out of range.
Fan fault.
Fan blocked by dust or fibres.
cooking Temperature sensor blocked for cook-
ing area.
Insufficient temperature variation de-
tected after switching on the hob.
Do not use empty or thin-based pots/
pans on the hob as it will be unable to de-
tect the temperature or turn off automat-
ically if the temperature is too high, thus
damaging the pan or the hob surface.
If this occurs, do not touch anything and
wait for all components to cool down.
If an error message appears, refer to
"Troubleshooting".
Hint/tips
Noise during cooking
When a cooking area is active, it may
hum briefly. This is a characteristic of all
ceramic glass hobs and does not impair
the function or life of the appliance. The
noise depends on the pan used. If it
causes considerable disturbance, it may
help to change the pan.
Solution
Remove water or pan from the ceramic
glass surface and control panel.
Let the hob cool down.
Please check if the hob has sufficient
ventilation.
If the error persists, please contact
After Sales Service.
Let the hob cool down.
Use a suitable pan.
Do not heat empty pans.
Use a suitable pan.
The error is automatically cancelled
after 8 seconds and the cooking area
can be used again.
If any other errors occur, the pan must
be changed.
If the error persists, please contact
After Sales Service.
Check mains voltage and/or fre-
quency.
If necessary, contact After Sales Ser-
vice.
Clean and remove foreign bodies from
the fan.
If the error persists, please contact
After Sales Service.
Switch off the hob and switch it on
again after cooling down.
If the error persists, please contact
After Sales Service.
13