Troubleshooting; Connectivity Diagram - FujiFilm Sonosite Edge Stand Guide D'utilisation

To remove the TTC
1 Remove any attached transducers.
2 Disconnect the transducer connector from the system.
3 Pull out the knob on each of the two mounting brackets, and slide the TTC out.

Troubleshooting

Symptom
Printer does not print.
Stand tips over more easily
than expected.

Connectivity diagram

Use the following diagram for assistance disconnecting and reconnecting peripherals. For more detailed
information, refer to the assembly instructions. Additional copies are available at www.sonosite.com.
See also "Cables and connectors"
Caution To avoid damaging the system, use only accessories and peripherals recommended
by SonoSite with the ultrasound system.
Troubleshooting
Solution
Check the printer selection on the Connectivity setup page.
See the ultrasound system user guide.
Check the cable connections. See the printer installation instructions.
Ensure that the printer is turned on and set up properly. See the printer
manufacturer's instructions, if necessary.
Lower the platform on the stand.
Avoid placing heavy objects on the platform. Too much weight on the
platform can cause the stand to become less stable.
on page 10.
9