FujiFilm SonoSite PowerPark Guide D'utilisation page 10

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
You can clean and disinfect the exterior surface of the PowerPark stand module using a recommended
cleaner or disinfectant. For the most recent list of approved products, see Cleaning and Disinfecting FUJIFILM
SonoSite Products, available at www.sonosite.com.
Caution
1 Turn off the ultrasound system and any accessory equipment. Disconnect the stand from the PowerPark
dock or unplug the power cord.
2 Clean the stand module surfaces to remove any debris or bodily fluids. Use the following procedure:
a Use either a pre-moistened wipe or a soft cloth dampened with cleaner or disinfectant.
b Remove all gel, debris, and bodily fluids from the PowerPark stand module.
3 With a new wipe, clean all parts of the PowerPark stand module by wiping from the clean areas to the
soiled areas. This method helps to avoid cross-contamination.
Follow the chemical manufacturer's instructions regarding temperature and wet contact time. Monitor the
PowerPark parts for wet appearance, and reapply with a new wipe if no longer wet.
4 Allow the PowerPark stand module to air dry in a clean, well-ventilated space.
To clean the PowerPark dock
Clean the PowerPark dock periodically, or whenever it appears dirty or comes into contact with biomatter or
bodily fluids.
Caution
1 Undock the stand, and disconnect the PowerPark dock from the AC power.
2 Clean the outside surface of the PowerPark dock to remove any debris or bodily fluids. Use either a pre-
moistened wipe or a soft cloth dampened with cleaner or disinfectant.
3 With a new wipe, clean all parts of the PowerPark dock by wiping from the clean areas to the soiled areas.
This method helps avoid cross-contamination.
Follow the chemical manufacturer's instructions regarding temperature and wet contact time. Monitor the
PowerPark parts for wet appearance and reapply with a new wipe if they are no longer wet.
4 Allow the PowerPark dock to air dry in a clean, well-ventilated space.
8
Do not allow cleaning solution or disinfectant to contact the PowerPark electrical
connectors.
Do not allow cleaning solution or disinfectant to come into contact with the
PowerPark electrical connectors.
PowerPark User Guide

Publicité

Table des Matières
loading

Table des Matières