Elesta NEW WAVE RTM500B Mode D'emploi page 17

The LED may flash continuously to shown that there is an error, for example, in
working as an active antenna. If there is an error in one of the channels of the
connected modules, this is also signalled by the device's LED.
The statuses shown by the two-colour LED vary according to the operating
mode:
Active antenna mode
Fixed green: device powered and ready to receive.
Fixed orange (short): a radio command was received and sent to the relay
modules.
Fixed red: association mode ongoing in the relay modules.
Flashing red (fast): communication error with relay module.
Any flashing colour (slow): repetition of the most significant error coming
from a relay module of the chain.
Repeater mode
Fixed green: device powered and ready to receive/transmit.
Fixed orange (short): a radio command was received.
Fixed red (short): a radio command was re-transmitted.
Flashing green (fast): no address to be repeated was learnt.
Flashing orange: self-learning of the channels to be repeated.
Receiver mode for PC
Fixed green: device powered and ready to receive.
Fixed orange (short): a radio command was received and sent to the PC.
Flashing red (fast): serial communication error.
INSTALLATION
The receiving system consists of at least one active antenna and a relay
module.
The best place to install the device should be decided based on the following
points:
- The antenna was designed within a small enclosure so that it could be easily
installed where the radio signal is the strongest.
17