Elesta NEW WAVE RTM500B Mode D'emploi page 16

has been re-transmitted.
If there is a problem with radio communication during the self-learning, it will
not be able to reach the third point of the procedure, the LED will continue to
flash in orange and the procedure will be interrupted automatically after 30
seconds.
The procedure can be interrupted also by pressing the self-learning key again.
It is recommended to repeat only the commands of the transmitters that
effectively have a range problem in contributing towards keeping the band as
free as possible.
Deleting a repeated address
There are two possibilities if you want to delete an address that has been
learnt, so that the commands of the corresponding transmitter are not repeated
any more: deleting the last address that has been learnt or deleting all the
memory.
To delete the last address, press the self-learning key and keep it pressed
down, the LED flashes quickly in orange and release the key when the LED
turns red. The deletion that has been executed is shown on the LED with a
green-red-green-red sequence.
To delete all the memory press the self-learning key and keep it pressed down
until you see the green-red-green-red sequence on the LED.
Working as a receiver for the PC
The device can be connected to a PC or a home automation controller, with
which it will communicate by means of the RS485 bus. To configure the device
as a receiver, leave the JP1 jumper inserted and remove JP2 (as shown with
C in Fig. 5). The device works as a receiver and no longer communicates with
the relay modules. In this configuration, 12VDC power supply must be supplied
to terminals 1- and 2+.
For further information on the operating mode and the communication protocol,
please contact your local distributor.
LED
1
The two-colour LED usually remains on in green and fixed to shown that
the device is powered and operational.
16