Dometic TEC 29 Notice D'utilisation page 20

Operating the generator
Display message
Description
OVER TEMPERATURE
Overheating
LOW POWER ENGINE
The inverter supply voltage
has dropped.
RESTART GEN?
Message appears after the
generator has stopped due to
overheating.
GEN CAL
Message appears when the
generator is started up; it
shows the calibration phase
which takes place before
each start-up. The generator
does not supply any voltage.
GEN WAIT
Message appears while you
are waiting for the generator
to start again.
GEN ON
The generator is operating
normally.
GEN OFF
AUTO?
Message appears when the
automatic mode is switched
on.
AUTO
Automatic mode
20
Generator behaviour
The inverter switches off so
no voltage is supplied to cool
the generator, but the engine
carries on running.
The generator stops.
The generator is switched off. Press the start button to
The generator is running but
does not supply any voltage.
The generator is switched off. Wait until the message has
Normal mode
The generator is in stand-by
and can be started.
Controls are waiting for user
input
The automatic mode is
switched on
TEC29, TEC29LPG
Measures
Leave the engine to cool
down for a few minutes then
start the generator again.
Reduce the connected load
and start the generator again.
restart the generator.
Wait a moment.
disappeared then attempt
ignition again.
–
–
Press the start button within
20 seconds and hold down
for 3 seconds.
–
EN