Acova Taïga LCD Notice D'utilisation page 17

N
FrOST PrOTeCTIOn mODe InDICATOr
Your radiator maintains a minimum room temperature of 7°C to prevent any risk
of frost.
This temperature cannot be modified by the user.
This mode is recommended when the room is unoccupied for periods longer
than 24 hours.
eCO mODe InDICATOr
This economic mode lowers the temperature by approximately 3.5°C compared
to the desired temperature level for the COMFORT mode.
This temperature cannot be modified by the user. It cannot exceed 19°C.
This mode is recommended when the room is unoccupied for periods longer
than 2 hours.
Operating example: if your radiator is set to 20°C in COMFORT mode, the ECO
mode setpoint temperature will be 16.5°C.
COmFOrT mODe InDICATOr
This is your radiator's normal operating mode. You can select your desired room
temperature using the - or + adjustment keys.
This temperature level can be adjusted between 7 and 28°C in 0.5°C
increments.
This mode is recommended when the room is occupied.
PrOgrAmmeS
The control panel on your appliance includes three non-modifiable programmes
which you can access by pressing the MODE key. They are based on different room
occupation scenarios which alternate the switching of your appliance from Comfort
mode to Eco mode depending on the time. You therefore need to set the time before
making any programme mode selection.
remInDer:
The setpoint temperature can be adjusted in COMFORT mode; the temperature
in ECO mode will be the same as the Comfort mode -3.5°C
32
PrOgrAmme P1
This programme can be selected when you need to heat your
room from 5 am to 11 pm (e.g. permanent presence).
PrOgrAmme P2
This programme can be selected when you need to heat your
room from 5 am to 9 am and from 5 pm to 11 pm (e.g. work day).
PrOgrAmme P3
This programme can be selected when you need to heat your
room from 5 am to 9 am, from 12 pm to 2 pm and from 5 pm to 11 pm
(e.g. work day with lunch break at home).
AUTO mODe InDICATOr
Auto mode allows your radiator to receive remote operating instructions from a
programming base unit (not supplied with your appliance). These instructions arrive
either using a pilot wire to which your radiator is connected, or a PLC (Powerline Carrier)
programming base unit via your electrical system.
If you're using a programming base unit, the mode transmitted will correspond
to your radiator's regular modes (NO HEAT, FROST PROTECTION, ECO, COMFORT).
It can also switch your radiator to two additional modes (COMFORT -1°C and
COMFORT -2°C).
Set the setpoint temperature on your radiator which corresponds to your requi-
rements in COMFORT mode using the - and + keys, then select AUTO mode by
pressing the MODE key repeatedly. Then consult the instructions supplied with your
programming base unit for information on operating your radiator with it.
If you're using a PLC programming base unit, please consult the instructions
supplied with it as well as the PLC association/disassociation paragraph for more
information (see chapter 4.4).
N
33