Adding Or Replacing An Expansion Card - eMachines H3120 Manuel De L'utilisateur

www.emachines.com

Adding or replacing an expansion card

Insert the front bezel's cables through the hole in the case behind the
11
bezel, then snap the bezel back into place.
Reconnect the front bezel's power and LED cables to the appropriate
12
connectors on the system board.
Replace the side panel by following the instructions in
13
panel" on page 147.
To add or replace an expansion card:
Remove the side panel by following the instructions in
1
panel" on page 144.
If you are adding a new expansion card, go to the next step. If you are
2
replacing an expansion card, go to
Remove the screw that secures the expansion card slot cover to the case,
3
then go to Step 7.
Disconnect any external cables that are attached to the expansion card
4
you are removing.
Remove the screw that secures the expansion card to the case.
5
Screw
Remove the PCI expansion card and place it in a static-free bag for storage.
6
You can gently rock the card end-to-end to loosen and remove the card
(do not bend the card sideways).
Adding or replacing an expansion card
Step 4.
Screw
"Replacing the side
"Removing the side
161