Replacing The Heat Sink - eMachines H3120 Manuel De L'utilisateur

www.emachines.com
Tips & Tricks
On some models, you may first need to
remove the heat sink fan.

Replacing the heat sink

Tips & Tricks
You need a Phillips screwdriver to add or
replace the heat sink.
Pull down on the side of the power supply nearest you, then remove the
5
power supply from the bay.
Slide the new power supply into the power supply bay until its back is flush
6
with the back of the case.
Use the four screws you removed previously to secure the new power
7
supply to the case.
Reconnect the power supply cables to the system board and to the drives.
8
Replace the side panel by following the instructions in
9
panel" on page 147.
To replace the heat sink:
Remove the side panel by following the instructions in
1
panel" on page 144.
Place the computer case on its side.
2
Disconnect the heat sink fan's power connector from the system board.
3
Connector
Replacing the heat sink
"Replacing the side
"Removing the side
157