eMachines H3120 Manuel De L'utilisateur page 161

CHAPTER 13: Adding and Replacing Components
154
Remove the screw that secures the hard drive bay to the case.
4
Slide the hard drive bay away from the system board and toward the open
5
side of the case, then remove the hard drive bay from the case.
If you are adding a new drive, go to
6
drive, go to the next step.
Remove the four screws that secure the hard drive to the drive bay. (Only
7
the two screws on one side of the bay are shown below.)
Slide the old drive out of the bay.
8
Slide the new drive into the drive bay.
9
Use the four screws you removed previously to secure the hard drive to
10
the hard drive bay.
www.emachines.com
Screw
Step 9. If you are replacing an existing
Screws