Kerbl 70239 Mode D'emploi page 7

Setup and commissioning
Proceed as follows:
1. Check the heating plate for damage.
2. Place the heating plate on an even surface.
3. To avoid heat losses and to optimise the transfer of heat to the animals / troughs, the heating plate should be
positioned on an insulated base. (e.g. polystyrene tile, piece of carpet or a wooden board at least 20 mm thick)
4. Remove any flammable or easily combustible material from the area around the heating plate.
5. Connect the supply line of the heating plate to the supplied mains adapter.
6. Connect the mains adapter to the 230 V power socket. After a short while, warmth can be felt on the heating plate
and mains adapter.
7. To switch off the heating plate, pull the plug out of the mains socket.
Maintenance and cleaning
CAUTION!
Risk of physical injury to people and animals and material damage
• Only perform maintenance and cleaning work when the mains plug is disconnected.
When carrying out cleaning and maintenance work, note the following instructions:
• Keep the device free from dust and soiling.
• Only clean the device with a soft cloth or damp towel. The cloth or towel should be free of petrol and / or other
solvents, since these can attack or damage the heating plate.
• Never immerse the heating plate in water or clean it with a water jet.
Technical data
Article number / type designation: 70239
Supply voltage:
Voltage after the transformer:
Output:
Heating plate protection class:
Mains adapter protection class:
Heating plate dimensions:
Weight:
Declaration of conformity
Albert KERBL GmbH hereby declares that the product / device described in these instructions complies with the fundamental requirements
and other relevant stipulations and regulations. The CE mark confirms compliance with the Directives of the European Union. The declaration of
conformity can be viewed by visiting http://www.kerbl.de.
Electronic scrap
Disposing of this device after its service life is the responsibility of the operator. Please consult the valid national regulations. The
device must not be disposed of in household waste. In accordance with the stipulations of the EU Directive on the Disposal of
Electrical and Electronic Devices, the device can be disposed of free of charge at the local waste collection or recycling centre. Alter-
natively, it can be returned to retailers who offer a collection service. The proper disposal helps to ensure environmental protection
and prevents any adverse effects on human health and the environment.
230 V AC, 50 Hz
24V DC
18 W (approx. 0.03 W / cm²)
III (IP X7)
IP 20
240 x 240 x 8 mm
approx. 1.2 kg
7