Bushnell BACK TRACK GPS HuntTrack Mode D'emploi page 6

• You can use the five icons (and up to 20 numbers)
to mark different locations of any kind (your truck,
treestand, a campsite, etc.). Be sure you select a
different icon or # to store each new location. If you
hold down MARK with a previously used location
icon still selected, you will replace that one with your
current location.
• To expand or restrict the number of "extra" locations
(numbers from 1 to 20) that are available, Press SETUP
(4) three times until the location arrow on the lower
right is highlighted. Press MARK (2), then use the
TRIP/DATA or SETUP buttons to decrease or increase
the number below the arrow (Fig. 6). Press the MARK
button to confirm and return to the Setup screen.
auTo PoWeR oFF/BackLiGHT
• Power automatically turns off after 10 minutes if no
buttons have been pressed (except in Trip mode,
described next). HOLD POWER to turn the unit off
manually.
• Press the MARK button to turn the display backlight
on. It automatically turns off after 30 seconds.
coMPaSS caLiBRaTion
• To ensure directional accuracy, hold the HuntTrack
out in front of you and move it in a "Figure 8" pattern
a few times to re-calibrate the compass (Fig. 7). A
compass calibration video is available at: http://www.
bushnell.com/products/gps/instruction-videos/.
• For best results, we recommend holding the
HuntTrack in a horizontal position (not tilted) during
use (Fig. 8).
6
Fig. 6
8
Fig. 7
Fig. 8