Poresta Systems Poresta Limit S 95 Mode D'emploi page 7

Einbauanleitung
Mounting instruction
Montagehandleiding
Instructions de montage
Istruzioni di montaggio
Use:
- The Poresta ® Limit S 95 shower system can be shortened by
the installer up to 50 mm laterally and variably on the long side,
considering the size, installation height and geometry of the shower
system/stainless steel grate system.
- The kind of utilization of the shower space (splash protection, move-
ment area, etc.) is to be considered.
- For installation of the shower system, a flat, clean, firm and vibra-
tion-less substrate suitable for cementing with Profi-Flex instant
adhesive is required.
- The offset drain position in the grate frame allows - due to the
resulting variable distance from the wall - the use of standard tiles
or natural stone as wall facing (see Fig. 18).
- The correct seating of the drain body is to be checked.
- The shower system is in general wheelchair-accessible, using tiles
of a minimum size of 100 x 100 mm. When incorporating a fiber-
glass cloth in the tile adhesive bed, tiles of a minimum size of 50 x
50 mm can be used.
- Suitable for indoor use only.
- The use of the Poresta sound-proofing set is only possible for
®
products with KMK coating and when using the KMK sealing acces-
sories.
The relevant working guidelines of all the trades involved
shall be observed.
For installation of the channel drain system, the attached
mounting instructions are to be observed.
1
Edge insulation strips are to be provided by the owner.
When installing substructure elements (not included in the
2
scope of supply or a cast screed base can be used. The
height of the substructure element/screed base is to be
chosen according to the difference in level between the
unfinished floor and flooring screed (also see installation
examples).
3
Tile adhesive must be applied to both sides.
After the installation of the drain fitting, a leak test has to be
4
carried out and the protection plate is to be inserted again.
Before inserting the gradient element, provide the drain line
5
with a suitable heat and sound insulation jacketing.
The processing instructions of the sealing system shall be
6
observed.
Choose correct distance of the channel from the wall by twist-
7
ing and pushing the grate frame. In the process, consider the
planned wall construction.
The hooks for removing the hair sieve and the supplied
8
instructions are to be handed over to the owner or to the
architect in the place of the owner.
Example for installation with Poresta
Mounting height/finished floor level
Poresta Limit S 95
®
2 layers of tile adhesive
Poresta BF substructure element (X)
®
Installation example with screed base (Y):
Mounting height/finished floor level
Poresta Limit S 95
®
1 layer of tile adhesive
Screed base (Y)
Poresta Limit S 95
®
BF substructure element (X):
®
140 mm
- 100 mm
-10 mm
= 30 mm
140 mm
- 100 mm
- 5 mm
= 35 mm