Varma Tec VARMA TOP IRK Mode D'emploi page 9

technician.
➢ In order to avoid overheating, do not cover the heater! If the power
cord is damaged, it must be replaced by the manufacturer or authorized
service agent or qualified personnel in order to avoid a hazard. In case of
doubt on installation, contact an authorized technician. The heater must
not be installed on a shelf.
➢ Do not use the appliance where flammable vapours are present
(spirit, insecticides, petrol, etc.).
➢ If you decide to stop using the appliance, switch it off and disconnect
it from the power supply, storing it out of reach of children and
differently able persons. Also cut off the power cable to render the
appliance unusable.
➢ Do not use the appliance in the immediate vicinity of bath tubs,
showers or swimming pools. Always respect the safety distances
prescribed by CEE-CEI standards.
➢ The appliance becomes very hot during use. Avoid all contact
between your skin and the hot surfaces of the appliance. Switch the
appliance off and wait at least 5 minutes for it to cool down before
performing any work on it
➢ Do not make modifications of any kind to this appliance.
➢ Pay special attention when using it in rooms that are not manned.
➢ Regularly inspect the appliance for visible defects. If any faults are
found, do not operate the appliance but contact Star Progetti
immediately.
➢ Never position the appliance directly under a power socket.
➢ The appliance must always be mounted horizontally
➢ The appliance must be properly connected to an electrical system in
compliance with the applicable regulations and equipped with an
efficient earthing system. If in doubt, have a qualified electrician perform
a thorough check.
➢ The appliance must be installed by a professional technician,
according to the instructions given in this booklet. Star Progetti cannot
assume any responsibility for damage to property or personal injury
resulting from failure to abide by the instructions given in this booklet.
➢ Use a multi-polar switch with minimum contact gaps of 3 mm when
installing the appliance.
➢ Connect the appliance to the electrical power supply only if the
system is able to provide the maximum electrical voltage and capacity
indicated on the rating plate at maximum power.
➢ Before carrying out any type of cleaning or maintenance operation,
turn the appliance off and turn the main power switch off to disconnect
it from the power supply.
➢ Should the appliance be dropped or suffer a heavy blow, have it
checked immediately by Star Progetti.
➢ When carrying out maintenance operations, never touch the bulbs
directly, but only the terminal casings. The bulb will be damaged by
contact with naked hands; in this eventuality the product guarantee will
no longer be considered valid.
➢ In the event of accidental contact with the surface of the bulb, clean
it immediately by wiping with a cloth dipped in denatured alcohol.
➢ If the appliance does not function correctly or develops a fault, turn
it off and contact Star Progetti immediately.
9