Kenwood KDC-BT73DAB Guide De Démarrage Rapide page 17

Antenna Installation
1
Check the installation location.
2
Clean the area where antenna film
(Accessory 4), amplifier unit (Accessory
5), and earth sheet are pasted with the
included cleaner (Accessory 7).
The coating on the metal surface need
not be removed.
• Wait until the glass surface is
completely dry before pasting.
• If the glass surface is cold, such as
during winter, warm it with defroster or
dryer.
3
Remove the separator (tag I) of antenna
film horizontally and paste the antenna
on the front glass.
• Remove the separator gently.
• Do not touch the pasting surface
(adhesive side) of the antenna film.
4
Remove the separator (tag II) of antenna
film vertically and paste the antenna
gently while applying pressure.
5
After pasting, rub the element in the
glass surface in the direction of the arrow
shown in the figure to bond it.
6
Remove the application film (tag III).
• Do not touch the feeder terminal of
the element. Also, do not apply any
glass cleaner.
7
Match the protrusion of the amplifier
with the 5 on the antenna film and
paste.
• Do not touch the feeder terminal or
the pasting surface (adhesive side) of
the amplifier.
• When installing the antenna on the
right side
Match the protrusion with 5
Accessory 4
Feeder terminal
Earth sheet
Accessory 5
English | 17