Instructions For Use - Campingaz PARTY GRILL 200 Mode D'emploi

Masquer les pouces Voir aussi pour PARTY GRILL 200:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 5
Rate: 145 g/h (2 kW)-injector n° 30
Category : butane direct pressure
Thank you for choosing a Campingaz® product.
A - IMPORTANT: ALWAYS BE CAREFUL
WHEN USING GAS !
• The purpose of these instructions is to enable you to
use your Campingaz® Party Grill 200 correctly and
safely.
• Please read them carefully to familiarise yourself
with the appliance prior to assembling the gas
cartridge.
• Please observe these instructions and the safety
measures printed on the Campingaz® CV 470 PLUS
/ CV 300 PLUS cartridges. Failure to observe these
instructions may result in the user and people in the
immediate vicinity being put at risk.
• Keep these instructions in a safe place so that you
can refer to them if needed.
• This appliance must be used exclusively with
Campingaz® CV 470 PLUS / CV 300 PLUS cartridges.
Using other gas cartridges may be dangerous.
• The Société Application Des Gaz accepts no
responsibility where cartridges of any other brand
are used.
• This equipment must be used only in areas that are
properly ventilated (minimum 2 m
from inflammable material.
• Do not use appliance which leaks, is damaged
or functions incorrectly. Instead, return it to your
retailer who will inform you of your nearest after-
sales service.
• Never modify this appliance or use it for purposes
for which it is not intended. Any modification of the
appliance could be dangerous.
• Do not use this appliance in caravans, cars, tents,
huts, sheds or any small enclosed areas.
• The appliance should not be used while sleeping or
left unattended.
• All appliances running on gas consume oxygen and
emit other potentially dangerous substances and
gases such as carbon monoxide (CO).
• Carbon monoxide is an odorless, clear gas that
can cause flu-like symptoms, sickness, illness, and
possibly death if produced inside aforesaid enclosed
areas through use of the appliance without proper
ventilation.
B - ASSEMBLY OF THE APPLIANCE
Remove the appliance from its packaging (Fig. 1).
(1) Lid
(4) Legs
(2) Cooking plate
(5) Water reservoir
(3) Pan support
(6) Base
1. (Fig. 2) Flip the appliance upside down. Screw legs into
the sockets at the bottom of the appliance.
2. (Fig. 3-A) Stand the appliance in upright position on level
ground. Install the water reservoir by resting it on the
base, with the viewing window facing front.

INSTRUCTIONS FOR USE

/h/kw) and away
3
3. (Fig. 3-B) Make sure that the notches on the inner circle
of the reservoir are in line with the locking tabs on the
base, then lock the reservoir into place by turning it
clockwise until it stops. The viewing window should face
front in line with the control knob when the reservoir is
installed (Fig. 3-C).
C- FITTING A CAMPINGAZ® CV 470 PLUS/
CV 300 PLUS CARTRIDGE
(If the existing cartridge is empty, read section § F,
"Removing the cartridge").
To fit or remove a cartridge, always work in a well ventilated
area, preferably outdoors, away from other people and
inflammable material, never near a naked flame, heat or
spark source (cigarettes, electrical equipment, etc).
AS
CAMPINGAZ®
CARTRIDGES ARE VALVE-OPERATED, THEY CAN
BE DETACHED FROM THE EQUIPMENT, EASILY
TRANSPORTED (EVEN WHEN NOT EMPTY) AND
FITTED TO OTHER CAMPINGAZ® EQUIPMENT IN THE
CV 470 PLUS / CV 300 PLUS RANGE DESIGNED TO
OPERATE EXCLUSIVELY WITH THESE CARTRIDGES.
1. (Fig. 4-A) Turn the control knob clockwise to the off
position (O) until it stops.
2. Flip the appliance upside down.
3. (Fig. 4-B) Gently screw in the gas cartridge by turning it
clockwise until you hear a click (approximately one-sixth
of a turn). Do not force the cartridge to turn further than
this; you will risk damaging the cartridge valve.
In the event of leakage (smell of gas prior to turning the
tap on), take the appliance outside immediately, in a well-
ventilated area with no combustion source, where the leak
can be located and halted. If you wish to check for leaks on
your appliance, do it outside. Do not try to detect leaks using
a flame, use soapy water.
D - PREPARATION FOR USE
1. (Fig. 5-A) Fill the reservoir with water to the "MAXI" level
(marked on wall of reservoir).
2. (Fig. 5-B) Place in the pan support (3), with its three feet
resting on the supports on the wall of the reservoir.
3. (Fig. 5-B) Place the cooking plate (2) over the pan
support, with its edge resting on the notches of the pan
support feet.
Do not use your appliance at a distance of less than 20 cm
from a wall or a combustible object.
Position the appliance on a stable, horizontal surface and
do not move when in use to avoid the appearance of large
flames resulting from the combustion of liquid butane
rather than vaporised butane. Should this occur, turn off
the control knob, and re-position the appliance.
Before lighting the appliance, make sure to fill the reservoir
with water to "MAXI" level, regardless whether
appliance is to be used as a stove or a grill.
Never leave the cooking plate on fire without foodstuffs
longer than one minute (except for the initial pre-heating
period) otherwise the special coating will be damaged.
Wait until the device has completely cooled down before
preparing it for storage.
Caution: some parts may be very hot. Keep young
children away from the appliance.
3
CV 470 PLUS / CV
300 PLUS
GB
the

Publicité

Table des Matières
loading

Table des Matières