Instructions For Use; C - Preparation For Use - Campingaz PARTY GRILL 400 Mode D'emploi

NOTE: Unless otherwise specified, following generic
terms "appliance / unit / product / equipment / device"
appeared in this instruction manual all refer to the product
"PARTY GRILL 400".
Thank you for choosing a Campingaz
These operation instructions are common to all PARTY
GRILL 400 units concerning their accessories and operation.
A - IMpORTANT: AlWAYS BE CAREfUl
WhEN USING GAS !
• This operation manual will help you use your
Campingaz unit properly and in complete safety.
®
• Consult the manual to familiarise yourself with the
appliance prior to assembling the gas cylinder.
• Abide by the instructions given in this manual. Failure
to do so may be dangerous for the user and anyone
else close by.
• Always keep this manual in a safe place, readily
available for reference if necessary.
• This unit is manufactured to use either butane or
propane, with a suitable regulator and a hose or
flexible hose, which are sold separately.
• This device must be used outside only and away from
flammable materials.
• Do not use appliance which leaks, is damaged or
functions incorrectly. Instead, return it to your retailer
who will inform you of your nearest after-sales
service.
• Never modify this appliance or use it for purposes
for which it is not intended. Any modification of the
appliance could be dangerous.
• Parts which are protected by the manufacturer
or the manufacturer's representative must not be
manipulated by the user.
• All appliances running on gas consume oxygen and
emit other potentially dangerous substances and
gases such as carbon monoxide (CO).
• Carbon monoxide is an odorless, clear gas that
can cause flu-like symptoms, sickness, illness,
and possibly death if emitted in aforesaid enclosed
areas through use of the appliance without proper
ventilation.
B - ASSEMBLy OF THE APPLIANCE
Remove the appliance from its packaging. Unlock latch by
following step sequence A, B, C, then open the lid (Fig. 1).
Remove components within the appliance (Fig. 2).
(1) Lid (Wok)
(2) Griddle
(3) Grid
(4) Heat distributor
1. (Fig. 3) Flip the appliance upside down. Screw legs into
the sockets at the bottom of the appliance.
2. (Fig. 4) Stand the appliance in upright position on level
ground. Install the water reservoir by resting it on the
base, with the viewing window facing front (Fig. 4-A).
3. Make sure that the notches on the inner circle of the
reservoir are in line with the locking tabs on the base,
then lock the reservoir into place by turning it clockwise
until it stops (Fig. 4-B). The viewing window should face
front in line with the control knob (Fig. 4-C) when the

INSTRUCTIONS fOR USE

product!
®
(5) Pan Support
(6) Legs
(7) Water Reservoir
(8) Base
reservoir is installed.
4. (Fig. 5) Attach lid handles to lid by driving screws through
holes on lid & handle from outside, then tightening with
dome nuts and washers from inside of the lid.

C - pREpARATION fOR USE

C-1 GAS CYlINDER AND REGUlATOR
When connecting or changing a cylinder, always operate in
an open, well-ventilated place, and never in the presence of
a flame, spark or any other source of heat.
This unit can be used with a CAMPINGAZ
type 904 or 907 and the CAMPINGAZ
mbar regulator.
It can also be used with other, larger, butane or propane
cylinders (5~15 kg) and the appropriate relief valves (consult
your dealer):
france, Belgium,
Ireland, Portugal, Spain, Italy, Greece:
butane 28 mbar / propane 37 mbar.
Netherlands, Norway, Sweden, Denmark, Finland,
Hungary, Slovenia,
Bulgaria, Turkey, Romania, Croatia:
butane 30 mbar / propane 30 mbar.
Switzerland, Germany, Austria:
butane 50 mbar / propane 50 mbar.
Poland: propane 37 mbar.
C-2 HOSES
Hose length should not exceed 1.50 meter. It must be
replaced if it is damaged or cracked, when required by
national regulations or when the expiry date on the hose is
passed. Do not pull on the hose or twist it. Keep the hose
away from any parts that may become hot. ** When the
hose connection is set up, check for gas leaks following
the instructions in section § D-1.
(Fig. 6 / 7) France:
The device must be used with a flexible hose designed to
be fitted into a threaded end piece on the device side and
held in place on the regulator with clamps (Standard XP D
36-110), recommended length 1.25 m.
Install the hose as described in the assembly instructions,
supplied with the hose and collars.
(Fig. 6 / 7) Belgium, luxembourg, United kingdom,
Ireland, Portugal,
Netherlands, Czech
Slovenia, Norway, Sweden, Denmark, Finland, Bulgaria,
Turkey, Romania, Poland:
The appliance is equipped with a circular connector. It should
be used with flexible hose that is suitable for use with butane
and propane gas.
(Fig. 6 / 8) Switzerland, Germany, Austria:
The appliance should be used with flexible tubing that is
suitable for use with butane and propane gas.
To connect the hose to the connector on the appliance,
tighten the nut on the hose firmly but without excess force
using two wrenches:
• no. 10 wrench to tighten the gas inlet on appliance
• no. 17 wrench to tighten the nut on the hose
Connect the other end to the regulator outlet.
17
butane cylinder
®
28-30 mbar or 50
®
luxembourg, United kingdom,
Slovakia, Czech Republic,
Spain, Italy, Croatia,
Republic, Slovakia, Hungary,
GB
Greece,