D-Link mydlink DCH-S150 Guide D'installation page 5

HARDWARE OVERVIEW
FRONT VIEW
Motion Sensor
WPS Blinking Green
Reset Solid Red
Solid Green
Blinking Green
(slow)
Blinking Green
(fast)
Power/Status
LED
Blinking Orange
Solid Red
Off
Motion
PIR (Passive Infrared) sensor for detecting motion.
Sensor
DCH-S150
Power/Status LED
WPS Button
Reset Button
Press for one second to start the WPS
connection process. The Power/Status
LED will start to blink green.
Press and hold until the Status LED turns
red in order to reset the device back to
the factory default settings (for about 10
seconds).
The DCH-S150 is successfully connected
to your network.
The WPS process is in progress.
The sensor is detecting motion.
The Motion Sensor is not properly
connected with your wireless network.
The Motion Sensor is powering on,
device is defective.
If the DCH-S150 will not power on, try
plugging the device into another outlet.
3