FEUERHAND PYRON PLATE Mode D'emploi page 10

ASSEMBLY
STEP 1:
Arrange the three arms of the sup-
port frame on an even surface (table)
and fasten them with the screws provi-
ded, the washers placed under the screw
heads and nuts. Make sure that all plate
hooks are facing in an upward direction.
STEP 2:
Ensure a steady stand of the Pyron before
placing the support frame on top. It should
be positioned on even, solid ground. Place
the assembled support frame, with the hooks
to hold the plate pointing upwards top-down
inside the Fire Barrel Pyron. Minimise pos-
DEUTSCH
sible gaps between the frame and Pyron by
carefully adjusting each arm and tighten
the screws.
STEP 3:
Place the Pyron Plate on the support frame
and insert the cooking support into the cen-
tre of the Pyron Plate.
PREPARATION AND INITIAL
OPERATION
INITIAL USE
During the fi rst use, the plate will arch. Due
to the material, it cannot be predicted if the
arching will take place upwards or downwards.
If the plate arched upwards please remove
the cooking support wearing heat resistant
gloves and park on a heat-resistant surface.
Turn the entire plate over so that it is arched
downwards and carefully reinsert the cooking
support. Afterwards, you may season your
Pyron Plate.
ENGLISH FRANÇAIS ESPAÑOL