Publicité
Les langues disponibles
Les langues disponibles
EN
I. PRECAUTIONS
•
It is forbidden to use the device if damaged or defective.
•
The device can't be used by any person with a physical or mental disability, children
or any person with insufficient experience, and/or insufficient knowledge.
•
Device must be kept away from children.
•
To prevent injuries, always be careful with the maintenance of the device, particularly
with the maintenance of the blades.
•
When cleaning or servicing the device be aware of all possible dangers or residual
risks.
II. THE CONSTRUCTION OF THE DEVICE
1
2
4
1.
3
2.
5
3.
6
4.
5.
6.
III. APPLICATION
The stripper is designed to be used with copper and aluminum cables and wires of
different diameters – from 1.5 mm up to 25 mm.
We do not take any responsibility for improper use. Any damage resulting from a non-
conform use of the device has to be paid by the user!
IV. BEFORE FIRST USE
Upon receipt of the goods, check the packaging for integrity and open it. If the packaging
is damaged, please contact your transport company and distributor within 3 days, and
document the damages as detailed as possible. Do not turn the package upside
6
U S E R M A N U A L
adjusting knob
blade
shaft
crank
pin for attaching the drill
cable / wire cutting channels
6
Rev. 28.02.2022
down! When transporting the package, please ensure to keep it horizontal and stable.
Please keep all packaging materials (cardboard, plastic tapes and styrofoam), so that in
case of return, the device can be sent back to the service centre in accurate condition.
V. USE OF THE DEVICE
1.
Fix the device in a sturdy location using all holes designed for mounting.
2.
Turn the crank and insert cable / wire into an appropriate cutting channel. Make
sure the cable / wire ends are free from any plugs etc. Cable / wire diameter should
be adjusted to the cutting channel size.
3.
A stripped cable / wire is ejected on the other side of the device. To avoid tangling,
jamming and/or device damage make sure the area surrounding the device is free
from any obstacles so that ejected material could fall unhindered.
4.
If the wires / cables have not been stripped properly (cuts are too shallow or too
deep) adjust using the adjuster (1). Tightening will cause deeper cuts, loosening -
shallower cuts.
5.
Attaching the drill:
•
Electric drill can be attached to the device. Remove the crank (4), screw the
pin (5) for attaching the drill:
6.
Do not insert fingers / hands into cable / wire cutting channels when the device is
on!
VI. CLEANING AND MAINTENANCE
After use remove excessive dust, grime and grease etc. from the device.
Store in a cool and dry place. For longer storage periods apply oil to cutting blades
and rollers.
Use red grease or molybdenum grease to lubricate bearings.
Rev. 28.02.2022
EN
7
7
Publicité
