tomado TIH3501S Mode D'emploi page 18

Pans that have already been used other hobs, such as gas hobs, are no longer suitable for an induction hob. Therefore, buy a new
pan prior to first use, if you do not have a suitable pan.
Metal frying pan
• Which requirements should a good pan meet? The pan should contain materials that are magnetic. Cookware made of steel,
enamelled steel, cast iron or stainless steel yields the best results.
• Use pans with a thick, flat bottom with the same diameter as a cooking zone. This reduces cooking time.
• The pans must have a flat bottom and a minimum diameter of 12 cm and maximum diameter of 20 cm. The cooking zone is
a circle and the point where the lines cross is the centre of the circle.
• After first use, white stains are sometimes found in the pan. This is normal. Pour some vinegar in the pan and heat it to
60-80°C. Then remove the stains with a brush.
• Unsuitable materials for pans are: glass, ceramic, aluminium, copper and other non-magnetic materials.
• When the pan is removed from the cooking zone, the induction hob immediately stops heating.
• A pan should always be placed in the centre of a cooking zone.
• In the case of some pans, it is possible that you can hear different noises. This is caused by the shape of the pan and does
not affect the function or safety of the induction hob.
ENERGY SAVING
• Place the pan on the cooking zone before it is switched on. If you switch on a cooking zone without a pan on top of it,
the cooking zone will do nothing.
• Always use a lid on the pan to reduce cooking time.
• Reduce the power when the liquid is boiling.
• Do not use too much liquid or fat. Cooking or frying takes longer if you use too much.
• Select the correct power for the different cooking possibilities.
Prior to cleaning, always remove the plug from the wall socket. Allow cooking zones to cool down before cleaning the induction hob.
• When cleaning the surface of the induction hob, do not use aggressive abrasive cleaning agents, spray cans or sharp
objects that have not been developed for this purpose.
• After a period of time, the ventilation openings can become clogged due to the accumulation of dust and other dirt.
Clean the ventilation openings with a soft, dry cloth. If necessary, use a soft brush or a mini vacuum cleaner.
Caution: Do not rinse the induction hob with water.
• Daily clean the surface of the induction hob with a damp cloth and a mild cleaning agent, such as a washing-up liquid.
Dry properly with paper towels or a dry tea towel.
• Some pans can leave a metal-like substance on the glass plate. Remove it immediately after use, because it will get increasingly
more difficult to remove. If necessary, use a damp cloth with a little bit of toothpaste or some washing-up liquid.
• If the induction hob is not used for a longer period of time, remove the plug from the socket and store the appliance in a room
that is free from dust and vermin.
• Boiled over food can be removed by soaking it with a damp cloth and a little bit of washing-up liquid, or you can use a glass
scraper. Caution: the glass scraper is sharp. Keep it away from children.
• Use a special cleaning agent for ceramic/induction hobs in case of stubborn stains. Caution: observe the instructions on the
packaging.
PANS
Stainless steel pan Enamelled pan
with metal bottom
CLEANING AND MAINTENANCE
EN - 18
Cast iron Kettle made of
grill plate stainless steel
or enamelled