Klarstein Touchstream WH Mode D'emploi page 13

USE AND OPERATION
• Unpacked all the packaging from the unit.
• Insert the plug into a 220~240V 50~60Hz electrical power supply outlet.
Press the buttons on the Touch Control Panel or Remote as below:
• Power: turn the fan on by pressing the ON/OFF button, to turn off the fan just press
the button again.
• Speed: Adjust the fan speed to a desired level: HI, MED, LOW, with its
corresponding indicator lighting up.
• Timer: Press Timer button, to set up to 1 hour to 7 hours timer setting, with its
corresponding indicator lighting up. The fan will automatically shut off when the
timer is over.
• OSC: Press OSC button to turn on the oscillation function. Press again to turn off.
CLEANING AND CARE
Always unplug the unit before moving or servicing. Do not immerse the power cord,
plug and the whole unit into water or rinse under the tap! Do not use detergent,
gasoline, benzene, thinner, or other solvents to clean the unit to avoid damage of the
appliance.
• Unplug the fan before cleaning.
• Use only a soft, damp cloth to gently wipe the outer surfaces of the fan clean.
• To clean between the grilles, we recommend using a pipe cleaner, flexible dust
wand, vacuum cleaner or compressed air to gently remove the dust.
• Take off the front cover carefully from the unit. You could wash the front cover under
running water. Rinse and dry the filter before place back.
• DO NOT immerse the fan in water and never allow water to drip into the motor
housing.
• DO NOT use gasoline, paint thinner or other chemicals to clean the fan.
• For storage, you may leave the fan assembled and covered to protect it from dust.
Store the fan in a cool, dry place.
EN
13