User Manual - Toolland FT5130 Mode D'emploi

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should
be taken to a specialized company for recycling. This device should be returned to your distributor or
to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Toolland. Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, do not install or use it and contact your dealer.
2. Safety Instructions
 This appliance should be installed in accordance to law and regulations. Always use this heater in
accordance with these instructions. Keep this manual for future reference.
 This heater is only for use in a well-ventilated area outdoors. Do not use indoors or in leisure vehicles such
as caravans.
 This device is not to be used in basements or as main heating.
 This device requires a flexible gas hose and gas regulator. Check with your gas supplier.
 Do not cover the heater with clothing or other fabrics to avoid risks of fire.
 Do not move a switched-on heater.
 Do not place a switched-on heater alongside walls or near furniture, curtains, bed linen or any other
flammable materials as this could result in a risk of fire.
 The following distances should be respected: 100 cm from the side, 150 cm from the front and 200 cm
above the device.
 Always face the heater toward the centre of the room.
 Place the heater on a level surface.
 If a leak is suspected, turn off the gas at the cylinder. Do not disconnect the regulator and extinguish all
open flames. Check all the connections, slowly turn the gas on and brush the connections with soapy water.
Soap bubbles may point to a gas leak. If a gas leak is found, turn off the gas and inform your gas supplier.
Do not use the heater again until it has been checked by your dealer.
 The changing of the cylinders must only be undertaken outdoors in a flame-free environment.
 The device is designed for use with butane/propane cylinders with a capacity between 7 and 15 kg.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
Keep this device away from dust and extreme temperatures.
Protect this device from shocks and abuse. Avoid brute force when operating the device.
 Familiarise yourself with the functions of the device before actually using it.
 All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to
the device is not covered by the warranty.
 Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
 Due to constant product improvements, the actual product appearance might differ from the shown images.
 Product images are for illustrative purposes only.
 Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
 Keep this manual for future reference.
V. 01 – 07/07/2015
FT5130

USER MANUAL

3 ©Velleman nv