Husqvarna 535LK Manuel D'utilisation page 10

To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows.
2. Move the spacer into the slot of the loop handle.
3. Attach the nut, the knob and the screw, do not make
it to tight.
4. Adjust the product to a comfortable position.
5. Tighten the bolt.
To assemble the two-piece shaft ()
1. Turn the knob to loosen the coupling.
2. Align the tab of the attachment (A) with the arrow of
the coupling (B).
B
10
3. Push the attachment into the coupling until it snaps
4. Tighten the knob fully.
To disassemble the two-piece shaft ()
1. Turn the knob 3 turns or more to loosen the
A
2. Push and hold the button (C).
3. Hold the engine end tight.
into place.
coupling.
331 - 003 -