Installing The Device; Using The Device - Dometic SabreLinkFlex Instructions De Montage Et De Service

Installing the device

6 Installing the device
I
NOTE
All 2021-onwards Dometic tents already have velcro stitched onto their
AIR poles. For those tents, adding the self-adhesive velcro is not
required.
6.1 Starter kit
➤ Proceed as shown (fig. 5, page 4 – fig. 7, page 4).
6.2 Add-on kit
➤ Proceed as shown (fig. 8, page 4).
7

Using the device

7.1 Before first use
1. Remove the plastic tab from the remote control's battery.
2. Pair the remote control to the remote receiver (fig. 0, page 5).
7.2 Switching on and off
➤ Proceed as shown (fig. 9, page 4).
7.3 Dimming the light
➤ To dim the light continuously ,proceed as shown (fig. a, page 5).
➤ To dim the light in percentage steps, proceed as shown (fig. b, page 5).
7.4 Changing the battery of the remote control
!
WARNING!
Keep batteries away from children.
➤ Replace the battery with a battery of the same type (3 V CR2025, see fig. 4,
page 3).
12
SabreLinkFlex
EN