Start-Up - Nordcap Polaris ICE 740 Super Manuel D'utilisation

Translation of the original instructions
This appliance is designed for indoor use and should only
be used to store food and beverages.
Conservation models (low temperature) have been realized
to store only pre-frozen products.
The device should not be used by people (including
children) of limited physical or motor capacity, or who lack
the necessary skill or expertise, unless aided or instructed
by another person responsible for their safety.
Children should be supervised to ensure they do not play
with the device.
Never place liquids or hot food into the appliance and do not
fill lidded containers to the top.
Never place carbonated beverages into the low-temperature
compartment.
They may explode.
In all appliances there are surfaces subject to frosting.
Depending on the model, frost may be melted away either
automatically (automatic defrost) or manually. Never attempt
to remove frost
You could irreparably damage the appliance.
Do not use any mechanical device or other artificial means
to accelerate the defrost process.
The Manufacturer declines all responsibility, and the
warranty shall be null and void, if electrical and/or
mechanical alterations are made to the product.
On arrival, check that the appliance has not incurred transport
damage and that it is complete according to the order.
In the event of visible damage immediately note the damage
on the transport documents with the following wording:
"RECEIVED WITH RESERVE FOR EVIDENT DAMAGE OF
PACKING".
ALL THE OPERATIONS INDICATED BELOW MUST BE
PERFORMED IN RESPECT OF EXISTING SAFETY
REGULATIONS, BOTH FOR THE EQUIPMENT IN USE
AND FOR THE OPERATING PROCEDURES
BEFORE BEGINNING HANDLING OPERATIONS
ENSURE THAT THE LIFTING CAPACITY IS
SUFFICIENT FOR THE APPLIANCE IN QUESTION
HANDLING with FORK LIFT or SIMILAR
Insert the forks into the side of back of the wooden pallet supplied
with the appliance.
Begin lifting checking that the appliance is in stable equilibrium.
DURING HANDLING OPERATIONS DO NOT TIP OR
IF IT'S NECESSARY TO TRANSPORT APPLIANCE
DIFFERENTLY AS IN ITS WORKING POSITION, YOU HAVE
TO WAIT AT LEAST 2 HOURS BEFORE OPERATING.
using a pointed object
TURNOVER
STACKING OF OTHER OBJECTS ON THE APPLIANCE
MUST BE ABSOLUTELY AVOIDED.
Remove the protection without using tools that may damage the surface.
Keep the packing out of the reach of children as it could be a danger hazard.
Dispose of the packing to the specialized collection or recycling points
(respect existing regulations).
Check that the serial number corresponds to the transport
documents.
The refrigerator equipment has been designed and manufactured
with the appropriate devices to guarantee the health and safety of
the user and does not contain dangerous edges, sharp surfaces
or protruding elements.
The stability of the machine is guaranteed even when the
doors are open; however, do not pull on the doors.
In the case of refrigerators with drawers, do not open more than
one drawer at a time and do not lean or sit on an open drawer,
so as to avoid overturning or damaging the refrigerator.
N.B.: In refrigerators with glass doors do not extract more
than one basket or rack at a time so as not to compromise
the stability of the refrigerator.
In case of appliance with wheels, when moving, take care
not to forcefully push the refrigerator so as avoid
overturning and damage. Also note any unevenness of the
surface on which the refrigerator is being pushed.
ALWAYS BLOCK THE WHEELS WITH THE STOPS
PROVIDED.
The A-weighted emission sound pressure level at
workstations NOT exceeds 70 dB(A);
Our appliances contain the refrigerant shown on the
corresponding rating plate as per Regulation (EC) No.
2037/2000 of 29 June 2000; in addition, the appliance is
composed of reusable or recyclable parts and materials.
Therefore, at the end of its lifetime, the appliance should be
delivered to a specific disposal center.
The best method to ensure that no one will remain trapped
inside is to take off the door completely.
The appliance must not be disposed of together with
household waste and metal scrap.
Absolutely avoid damaging the refrigeration circuit,
particularly near the heat exchanger.
COMPLY WITH LOCAL REGULATIONS
IN FORCE CONCERNING THE FINAL
DISPOSAL OF THIS TYPE OF
EQUIPMENT.
ENGLISH 3
KEEP DRY
3