BTI BH 2-26 Notice Originale page 36

OBJ_BUCH-3325-001.book Page 36 Friday, September 22, 2017 4:26 PM
tives 2011/65/EU, 2014/30/EU, 2006/42/EC in-
cluding their amendments and complies with the
following standards: EN 60745-1, EN 60745-2-6,
EN 50581.
Technical file (2006/42/EC) at:
BTI Befestigungstechnik GmbH & Co. KG
74653 Ingelfingen, GERMANY
ppa. Stephan Uder ppa. Martin Mayer-Ha-
Head of Procurement gelstein
Department Director Marketing & E-
Commerce
BTI Befestigungstechnik GmbH & Co. KG,
Salzstraße 51, 74653 Ingelfingen, GERMANY
Ingelfingen, 01.09.2017
Assembly
 Before any work on the machine itself, pull the
mains plug.
Auxiliary Handle
 Operate your machine only with the auxiliary
handle 14.
Changing the position of the auxiliary handle
(see figure A)
The auxiliary handle 14 can be set to any position
for a secure and low-fatigue working posture.
– Turn the bottom part of the auxiliary handle 14 in
counterclockwise direction and swivel the auxil-
iary handle 14 to the desired position. Then
retighten the bottom part of the auxiliary handle
14 by turning in clockwise direction.
Pay attention that the clamping band of the auxilia-
ry handle is positioned in the groove on the hous-
ing as intended for.
36 | English
Adjusting the Drilling Depth (see figure B)
The required drilling depth X can be set with the
depth stop 13.
– Press the button for the depth stop adjustment
12 and insert the depth stop into the auxiliary
handle 14.
The knurled surface of the depth stop 13 must
face downward.
– Insert the SDS-plus drilling tool to the stop into
the SDS-plus tool holder 3. Otherwise, the mov-
ability of the SDS-plus drilling tool can lead to in-
correct adjustment of the drilling depth.
– Pull out the depth stop until the distance be-
tween the tip of the drill bit and the tip of the
depth stop corresponds with the desired drilling
depth X.
Selecting Drill Chucks and Tools
For hammer drilling and chiselling, SDS-plus tools
are required that are inserted in the SDS-plus drill
chuck.
For drilling without impact in wood, metal, ceramic
and plastic as well as for screwdriving and tapping,
use non-SDS-plus drilling tools (e. g., drill bits with
cylindrical shank). A keyless drill chuck is required
for such drilling tools.
Changing the Key Type Drill Chuck
(BH 2-26)
To work with tools without SDS-plus (e.g., drills
with cylindrical shank), a suitable drill chuck must
be mounted (key type drill chuck or keyless chuck,
accessories).
Mounting the Key Type Drill Chuck (see figure C)
– Screw the SDS-plus adapter shank 18 into a key
type drill chuck 17. Secure the key type drill
chuck 17 with the securing screw 16. Please ob-
serve that the securing screw has a left-hand
thread.
Inserting the Key Type Drill Chuck (see figure C)
– Clean the shank end of the adapter shank and
apply a light coat of grease.
– Insert the key type drill chuck with the adapter
shank into the tool holder with a turning motion
until it automatically locks.
– Check the locking effect by pulling the key type
drill chuck.
Removing the Key Type Drill Chuck
– Push the locking sleeve 5 toward the rear and
pull out the key type drill chuck 17.
1 609 92A 41Y • 22.9.17