Publicité
27636xx0
27658xx1
2
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Max. flow rate of handshower
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
•
For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
•
Please read over these instructions thoroughly be-
fore beginning installation. Make sure that you
have all tools and supplies needed to complete
the installation.
•
To prevent scald injury, the maximum output tem-
perature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum out-
put temperature can be no higher than 112° F.
•
The screws and anchors included with this set
are suitable for use in a tile or other solid surface
wall. They are not suitable for use in an acrylic
or fiberglass shower enclosure. Please contact
the manufacturer of the enclosure regarding
recommended mounting locations, reinforcement
requirements, and mounting hardware.
•
This unit does not include a wall supply. It must
be used with Hansgrohe model 27458xx3 or
another approved supply that complies with
ASME A112.18.1/CSA B125.1 including ASME
A112.18.3.
•
Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
2.5 GPM
Publicité
