Waeco PerfectView LCD250 Instructions De Montage Et De Service page 36

Technical description
5.2 Operating elements
The following control elements are located on the monitor:
No. in fig. 0,
Description
page 6
1 –
2 C1/C2
3 MODE
4 MENU
5 –
6 +
7 C1 (BRI.)
8 C2 (CONT.)
9 COLOR
10 POWER
Note
I
Some of the buttons and LEDs have two functions. The second function of a but-
ton and LED is used in setup mode (see chapter "Using the LCD-monitor" on
page 45).
The camera consists of the following elements:
No. in fig. a,
Description
page 7
1 6-pin connection cable
2 Infrared LEDs
3 Microphone
36
Description
Both mini switches activate the mirror function for
camera 1 or camera 2.
Switches from camera 1 to camera 2 and vice-versa.
Reduces the brightness to prevent glare.
Saves the picture settings for each camera.
Switches to setup mode (see chapter "Using the
LCD-monitor" on page 45).
Reduces the volume.
Increases the volume.
This LED is lit if camera 1 appears on the display.
This LED is lit if camera 2 appears on the display.
This LED is lit orange if the monitor is operating in
day mode.
It is lit green if the monitor is operating in night mode.
Switches the monitor on and off.
PerfectView LCD250