Waeco PerfectView LCD250 Instructions De Montage Et De Service page 34

Safety and installation instructions
Observe the following instructions when handling the LCD monitor:
Do not open the monitor (fig. 4, page 4).
Do not submerge the monitor in water (fig. 5, page 4); the monitor is not waterproof.
The monitor must not impair your vision when driving (fig. 8, page 5).
Do not use the monitor when you are driving.
Do not operate the monitor with wet hands.
Do not operate the monitor if the housing has been damaged.
Connect it to the correct voltage.
Do not use the monitor during a storm (especially during a thunderstorm).
Do not use the monitor in areas which
– Are subjected to direct sunlight,
– Are subject to strong temperature fluctuations,
– Have high levels of humidity,
– Are poorly ventilated,
– Are dusty or oily.
Do not press against the LCD display.
Do not drop the monitor.
If you use the monitor in vehicles, the vehicle should be running during operation to
prevent the vehicle battery from discharging.
The picture quality can be impaired in the vicinity of electromagnetic fields.
For this reason do not mount the monitor near loudspeakers.
The camera is waterproof, however, you should observe the following instructions when
handling the camera:
Do not spray the camera directly with a high-pressure cleaning device.
Do not open the device, as this impairs the sealing and the function of the camera.
Do not pull at the cables, as this impairs the sealing and the function of the camera.
The camera is not suitable for underwater operation (fig. 5, page 4)!
34
PerfectView LCD250