Waeco PerfectView LCD250 Instructions De Montage Et De Service page 33

PerfectView LCD250
If you disconnect the negative terminal of the battery, all data stored in the volatile
memories will be lost.
The following data must be set again, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate operating
instructions.
Observe the following installation instructions:
Secure the monitor in such a way that it cannot become loose under any circumstances
(sudden braking, accidents) and cause injuries to the occupants of the vehicle.
Do not attach the monitor in the air bag deployment path, as this could cause injury if
the airbags are triggered.
To prevent damage, when drilling ensure that there is sufficient space on the other side
for the drill head to come out (fig. 2, page 4).
Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp
(fig. 1 1, page 3) or a voltmeter (see fig. 1 2, page 3).
Test lamps with an illuminant (fig. 1 3, page 3) consume voltages which are too high
and which can damage the vehicle's electronic system.
When making electrical connections, ensure that
– They are not kinked or twisted,
– They do not rub on edges,
– They are not laid in sharp edged ducts without protection (fig. 3, page 4).
Insulate all connections.
Secure the cables against mechanical wear with cable binders or insulating tape,
for example to existing cables.
Safety and installation instructions
33