FUXTEC FX-EB152 Mode D'emploi Original page 49

32. Troubleshooting
1. Difficulties during commissioning
Situation
Spark plug
No ignition
spark
other
Compression
Weak
ignition
The carburetor does
spark
not pump oil
anymore.
normal oil supply
but weak
compression
normal oil supply
and proper ignition
spark
Original User Manual FUXTEC FX-EB152/FX-EB162_de_en_fr_rev15
Cause
Carbon deposit between the
diodes of the spark plug
ignition coil defective flywheel
magnet too weak
Too much petrol in the
combustion chamber, bad fuel or
water in the tank
Oil line blocked
Piston rings worn, spark plug not
screwed down, cylinder head not
tight wrong valve clearance or
ignition timing.
Poor contact between ignition
cap and spark plug
49
Solution
Clean the spark plug.
Adjust the gap
0.6~0.7mm, Replace
the spark plug
Replace the ignition coil
or flywheel
Remove the spark plug
and allow to dry,
replace fuel.
Cleaning the carburetor
and cleaning the pipes
replace screw tight to
replace or adjust
Replace or check