Remote Control; Notes For Use; Location; Filter Element - Profi Care PC-LR 3083 Mode D'emploi

Remote Control

The range of the remote control is limited.
When using the remote control, please ensure that there
are no obstacles placed between it and the sensor on the
appliance.
1. Open the battery compartment cover on the back of the
remote control.
2. Insert 2 batteries of type R03 "AAA" 1.5 V, observing
the correct polarity (see markings on the bottom of the
compartment)!
3. Close the battery compartment cover.

Notes for Use

• The air purifier is not a substitute for medical treatment
required when facing pre-existing allergic conditions. If
you are not sure, always consult your doctor.
• By the use of the special filter system, the air purifier
removes harmful spores causing the formation of mould
from the ambient air. Thus, both the risk of mould
spreading and health-related issues is reduced.
NOTE:
In case mould is already present in the room, it cannot
be removed anymore just using the air purifier.
• Unpleasant odours are removed.

Location

• A skid-proof, even surface is suitable as installation loca-
tion. The appliance operates more effectively, if you keep
the windows and doors closed during operation.
• Maintain the following safety distances:
- 30 cm all around
- 120 cm to the ceiling
NOTE:
Do not forget to air on a regular basis.

Filter Element

Your appliance features a 4-filter system, consisting of the
following filter stages:
• Pre-filter, retains coarse particles
• HEPA filter, retains fine dust particles, pollen etc.
• Activated carbon filter that, among other things, can
remove odours
• Catalysis filter that neutralizes harmful environmental
gases.
For more information about the filter element, see "Clean-
ing / Maintenance".
48
PC-LR3083_IM_new2_14.01.2021

Electrical Connection

1. Connect the power adapter with the connecting socket of
the appliance.
2. Plug the power adapter into wall outlet. You will hear a
beep sound and all indicator lamps light up briefly. Addi-
tionally, the ring lights up. The appliance will then enter
standby mode. The value PM2.5 is displayed.

Operating Buttons

The buttons on the appliance are sensor touch buttons. In
order to perform the corresponding function gently touch the
buttons. Whenever a button is pressed, it will be confirmed
by a beep sound.
Control Remote
Panel Control
ON / OFF
SPEED SPEED
—
CHILD LOCK 3s
TIMER ON TIME
TIMER OFF TIME
FILTER
—
REPLACE
ANION ANION
SLEEP SLEEP

APD Sensor

(Air Pollution Detection)
The appliance is equipped with an APD sensor that is moni-
toring the air quality. It indicates the air quality as follows:
PM2.5 value in
*1
Colour
the display
1 to 75 green
75 to 150 yellow
150 to 300 red
H (>300) red
PM2.5 is the threshold for fine dust. These microscopic
*1
particles, with a size of up to 2.5 microns, naturally float
in the ambient air. Depending on conditions such as the
condition of the room, the sensor and filter status and
other environmental influences etc., this limit can vary.
Function
On / off
Power level selection
( , , , and Auto)
Wi-Fi connection is
activated
Child lock
Time-delayed switch on:
to
Time-delayed switch-off:
to
Filter reset
Ionizing function
Sleep mode /
power saving mode
Evaluation
good
satisfactory
poor
poor
14.01.21