FUXTEC FX-LB152P Mode D'emploi Original page 42

Original User Manual FUXTEC Petrol leaf blower FX-LB152P_de_en_fr_ita_rev01
30. Start/stop the leaf blower
The device must not be put into operation until you have read this operating manual,
observed all the instructions given and the device has been completely and correctly
installed!
•
Only start the device when it is completely assembled.
•
Support the device on the ground for starting and hold it firmly.
1. Maintain a distance from flammable materials.
2. Take a safe standing position.
3. Place the device on the ground in front of you
4. Hold the device by the upper bracket with your left hand
5. Grasp the pull starter with your right hand
Starting with cold engine
1. set the speed control to the middle position "I" (picture 9).
2. Gently press the primer pump several times until fuel enters the pump (picture 11).
3. set the choke to the "RUN" position (picture 10)
4. Pull out the starting cord 7 at the starting
5. Pull quickly on the start cord and then release it slowly.
Do not pull out the starting cable completely and do not let the starting handle snap back
on the engine.
6. Push the starting lever (choke) to
started
7. The engine rotates in idle speed
8. Before starting work, let the appliance warm up at idle for about 2-3 minutes and slowly start to
pull the throttle lever 2.
handle slowly until resistance is reached.
approx. 20-30sec. after the engine has
42