Steel Jacks
English
Operating Instructions
The steel jacks are only suited for manual operation.
Lifting the load by turning the crank in clockwise direction.
Lowering the load by turning the crank in counter-clockwise direction.
Design with safety ratchet crank
Lifting:
Set the selector switch to the position „Up"
Turn the lever (ratchet) clockwise to lift the load.
Lowering:
Set the selector switch to the position „Down"
Turn the lever (ratchet) anti-clockwise to lower the load.
Always position the load centric to head or claw within load centre area.
When loading on the claw, the load always has to be close to the claw shaft.
The centre of gravity of the load must be in the internal claw half.
Design with adjustable claw
Adjusting of the claw
unlocking
technische Änderungen vorbehalten
design changes under reserve
00.05.008
Always completely insert the claw.
Never insert in upper or lower opening only.
changements techniques sous réserve
lowering
lifting
Down
Up
Heben
Senken
Lifting
Lowering
Lever
Baisser
Supervise the installation
centre of gravity
Load Center Area
Seite / page 11