Trotec MultiMeasure BASIC BP10 Manuel D'utilisation page 25

1. Point the device at the object to be measured and
hold down the "MEAS" (2) button.
– The device turns on and carries out a measu-
rement. The "SCAN" symbol (15) appears in the
display. The current measured value is shown.
2. Release the "MEAS" button (2).
– The device stops measuring. The "HOLD"
symbol (16) appears in the display. Depending on
the setting of the device, either the maximum or
minimum value of the last measurement is shown.
The device switches off after approx. 10 seconds without
being used.
EN
Settings
Laser pointer / display backlight
• Press the "Laser" button (5) once to switch on the
laser pointer. The "Laser pointer on" symbol (17)
appears on the display.
• Press the "Laser" button (5) twice to switch on the
display backlight.
• Press the "Laser" button (5) three times to switch off
the laser pointer.
• Press the "Laser" button (5) four times to switch off
the display backlight.
Operating manual - Infrared thermometer BP10
B - 9