Publicité
Les langues disponibles
Les langues disponibles
LED WORk LIGHT
When impact driver is activated by pulling the trigger switch (1), the integrated
LED work light (9) will automatically illuminate the work area. NOTE: The work light is
for lighting the immediate work surface and is not intended to be used as a flashlight.
Bit Tip Storage
Two magnetic bit storage slots (5) are built into the area on the top of the tool.
Battery fuel Gauge - figure G
The tool is equipped with a battery fuel gauge (8).
This can be used to display the current level
of charge in the battery during use and during
charging. It does not indicate tool functionality
and is subject to variation based on product
components, temperature and end-user application.
Checking battery charge during use:
• Press the battery fuel gauge button (G1).
• The three LEDs (G2) will illuminate indicating the
percent of charge in the battery (figure G).
• If LED light does not lluminate, charge battery.
NOTE: This battery is designed to not operate
when a charge below 20% of its capacity is reached. After the battery charge is
depleted, the tool will not operate until after the battery has been recharged.
Belt Clip - figure H
A belt clip (10) is provided which can be switched
to either side of the tool based on user preference
for convenient access and storage during use.
• Place the front lip of the belt clip (H1) into the
indentation of the base (H2).
• Secure the belt clip with the supplied screw and
firmly tighten with a phillips screwdriver.
CAUTION
Ensure the forward/reverse control
:
button (2) is in the center lock position before
attaching tool to belt.
Problem
• Unit will not start.
• Battery pack will not charge. • Battery pack not inserted into charger. • Insert battery pack into
TROUBLESHOOTING
Possible Cause
• Battery pack not installed properly.
• Battery pack not charged.
• Charger not plugged in.
• Surrounding air temperature
too hot or too cold.
G
H
10
10
G1
H2
H1
Possible Solution
• Check battery pack
installation.
• Check battery pack
charging requirements.
charger until LED
lights.
• Plug charger into a
working outlet. Refer to
"Important Charging Notes"
for more details.
• Move charger and battery
pack to a surrounding air
temperature of above 40
degrees F (4,5°C) or below
105 degrees F (+40,5°C).
G2
Publicité
