Replacing The Silicone Profile On The Offset Bar - Orved bright 315 Mode D'emploi Et D'entretien

MAINTENANCE AND TEChNICAl SUPPORT

11.11 REPlACING ThE SIlICONE PROFIlE ON ThE OFFSET BAR

1) Open the Plexiglas cover as far as possible (95°) (Fig. 1).
2) Remove the silicone profile on the offset bar (Fig. 2).
3) Clean the seat with a cloth soaked in alcohol.
4) Put in a new silicone profile, pushing it in a uniform manner (Fig.
3). Do not stretch the silicone profile when fitting it in.
78
Rev. 05 - 04/2018 - Cod. 1500458 - Instruction manual for vacuum chamber packaging machines with digital control panel "Serie Bright"
Fig. 1
Fig. 2
Fig. 3