VONROC CD501DC Traduction De La Notice Originale page 5

- it becomes wedged in the workpiece.
f) Hold the machine with a firm grip. High reaction
torque can briefly occur while driving in and
loosening screws.
g) Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
h) Always wait until the machine has come to a
complete stop before placing it down. The tool
insert can jam and lead to loss of control over
the power tool.
2. MACHINE INFORMATION
Intended use
This cordless drill is intended for driving in and
loosening screws as well as for drilling in wood,
metal and plastic.
TECHNICAL SPECIFICATIONS
Model No.
Voltage
Chuck capacity
Torque settings
No load speed
Position 1:
Position 2:
Weight
Sound pressure level L
PA
Sound power level L
WA
Hand-arm vibration a
h
(screwdriving without impact)
Hand-arm vibration a
h,D
(Drilling into metal)
Only use the following batteries of the VONROC PO-
WER 20V battery platform. Using any other batteries
could cause serious injury or damage the tool.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC POWER 20V battery
platform are interchangeable with all the VONROC
POWER 20V battery platform tools.
WWW.VONROC.COM
CD501DC
20V
13 mm
21+ Drill mode
0-400 /min
0-1500 /min
1.15 kg
89.9 dB(A), K=3dB(A)
99.9 dB(A), K=3dB(A)
0.700 m/s K=1.5 m/s
2 2
1.746 m/s K=1.5 m/s
2 2
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN60745; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
1. Machine
2. Battery (not included)
3. Battery unlock button
4. Work light
5. On / off switch
6. Torque adjustment ring
7. Chuck
8. Gear selection switch
9. Direction switch
10. Belt hook
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
The battery must be charged before first use.
Inserting the battery into the machine (Fig. B)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (2) into the base of the machi-
ne as shown in Fig. B.
2. Push the battery further forward until it clicks
into place.
EN
5