Vetus HATO212B Instructions D'installation Et Manuel D'utilisation page 14

12 V / 24 V
5.8 Connections
5.8.1 Outlet
Non-return valve::
Place the non-return
valve (G) onto the
outlet hose. Tighten
the non-return valve
using the hose
clamp (H).
Reducing piece:
1 Place the reducing
piece (Q) into the
1
non-return valve.
2 Fix the reducing
piece using the
hose clamp (H).
 Fit the outlet hose
(ø 19 mm).
4 The reducing
piece can be fit-
ted in any position
3
so that the outlet
hose can be led
to the left, right,
up or down as
required.
5 The bent part of
the reducing piece
can be sawn off in
order to lead the
outlet behind the
toilet.
For the outlet pipe
use a 19 mm internal diameter hose (such as the 'Vetus imper-
meable 'no smell" sanitary hose').
Fix the outlet with clamps.
5.8.2 Water supply
The flexible water supply hose attached to the motor housing
has a /4" connection.
Connect the flexible water supply hose to the ball valve on the
water supply pipe.
14
110128.01
G
H
2
Q
Q
H
Q
H
4 5
Q
Q
5.9 Fitting the toilet pot
Do not fit the toilet pot permanently until all the connections
have been made.
Make sure that the plastic socks (D) are on the threaded
studs.
Fit the pot over the threaded studs and fix it provisionally.
H
12 V / 24 V
Electric marine toilets HATO...