Vetus HATO212B Instructions D'installation Et Manuel D'utilisation page 10

1 Introduction
Vetus toilets, model 'HATO...', are toilets with an integrated
grinding system. Provided that the toilets have been installed
correctly and are used normally they function like a normal
toilet.
The Vetus toilet may only be used for grinding and dispos-
ing of faeces and toilet paper.
The toilet is not suitable for grinding other objects such
as cotton wool, tampons, sanitary towels, condoms, and
hairs, or for pumping away liquids such as oil. This can
cause damage to the installation!
Make sure that there is always a pair of rubber gloves on
board.
10
110128.01
N.B.!
2 Working
12 V / 24 V:
The particular cycle chosen is carried out
automatically after operating the appropri-
ate button.
A choice can be made between the
'ECO' cycle of about 10 seconds and the
'NORMAL' cycle that lasts about 20 sec-
onds.
120 V / 230 V:
When the button on the toilet pot is
pressed the cycle is carried out automati-
cally.
This lasts for about 25 seconds.
The cycle consists of:
• A flushing phase:
The magnetic valve allows water to run into the toilet for a set
time.
• A grinding / pumping phase:
The motor drives the knife blades and the pump. The faeces
and toilet paper are ground up and pumped away.
• A phase in which the water seal is brought back to the nor-
mal level:
The magnetic valve allows water to run into the toilet for a set
time. This forms a water seal and prevents smells in the toilet
pot.
3 Safety
Make sure that the power supply is switched off when any main-
tenance or necessary repairs are carried out.
Electric marine toilets HATO...