Packaging; Chapter 7. Ordinary Maintenance; Instructions For Ordinary Maintenance Work; Sealing Blade Cleaning - Minipack-Torre RP40 Instructions Pour L'installation, L'emploi Et L'entretien

Chapter 6. Machine adjustment and setting up

6.9. Packaging

By pushing the cover handle with a pressure of 15 Kg. the
cover rests on the sealing blade; by pinching the film, it is
automatically sealed on the open sides (right and front).
In case you have selected the function "SEALING +
SHRINKWRAPPING" (programs P02÷P10) you will see
the film shrink onto the product.
Slightly decrease the pressure on the cover handle to
allow film detach from the sealing area on the inside.
With the right and detach the film from the sealing blade
towards the outside.

Chapter 7. Ordinary maintenance

7.1. Instructions for ordinary maintenance work

ORDINARY MAINTENANCE MUST BE CARRIED OUT BY QUALIFIED, APPROPRIATELY TRAINED STAFF.
Before carrying out maintenance, switch the machine off with the main ON/OFF switch, disconnect it
and wait for the machine to cool down!

7.2. Sealing blade cleaning

Using a dry cloth, wipe any film residues off the sealing

blade: do this at once after sealing since they are
easier to remove when still warm
For improved cleaning, regularly lubricate the sealing

blade with the Teflon non-stick grease supplied with
the machine.

7.3. Plastic film and other scrap removal

Wait for the machine to cool down completely before

removing any scraps stuck to the hot parts of the
machine (e.g. , on the flaps of the heat chamber)
If the lower cover requires cleaning (where the fan is

installed), remove the reticulated plate (17) and take
out any pieces that may have fallen inside (figure A)
When the reel on the automatic rewinder (29) is full,

remove the film by unscrewing the knob (30) and
taking away the disk (31) (figure B).

7.4. Machine cleaning

To clean the upper hood (18), clean both the
outside and the inside with water and soap only
(figure A).
Do not use any detergents with solvents which
could damage the upper hood (18) and reduce
the transparency.
Use a cloth moistened with water to clean the machine

If the machine works in a dusty environment it is

necessary to clean it more frequently inside as well as
outside. We especially recommend you vacuum up the
dust which settles on the interior electrical components
(figure B).
figure A
figure A
23
EN
EN
figure B
figure B